Newland FM420 Manual descarregar pdf (Página 135)

nlscan.com

Page 126

Preﬁx/SufﬁxPreﬁx/Sufﬁx

Code Programming ON

Code Programming OFF

Tools

Program “CODE” as user sufﬁx (The hex of “CODE” are 0x43, 0x4F, 0x44, and

0x45):

1. Read “Code Programming ON”

2. Read “Program User Sufﬁx”

3. Read “4,3,4,F,4,4,4,5” in order

4. Read “Save Programming”

5. Read “Code Programming OFF”

6. Read “Allow User Sufﬁx” to enable above programming. “CODE” will

appear to the right of a barcode.

User Sufﬁx

Disable or Enable User Sufﬁx

User sufﬁx is appended to the right of barcode message. For example, if user sufﬁx

is “AB”, and the barcode message is “123”, The Host receives “123AB”.

**Disable User Sufﬁx

【Pro CMD：0306000】

Enable User Sufﬁx

【Pro CMD：0306010】

Program User Sufﬁx

Read “Program User Sufﬁx”. Then program user sufﬁx byte(s). To end the

sufﬁx, read “Save programming”. The user sufﬁx byte is programmed in its

hex values. See example below.

Note: The maximum length for user sufﬁx is 10 bytes.

Program User Sufﬁx

【Pro CMD：0301000】

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 155 156

Sem comentários

Newland FM420 Manual Página 135