Newland FM420 Manual descarregar pdf (Página 129)

nlscan.com

Page 120

Preﬁx/SufﬁxPreﬁx/Sufﬁx

Code Programming ON

Code Programming OFF

Tools

General Programming

User Preﬁx is added before barcode message. For example, if the user

preﬁx is “AB” and the barcode message is “123”, the Host receives

“AB123”.

Program User Preﬁx

Enable “Program User Prefix”. Then program user prefix byte(s). To end the prefix,

read “Save programming” The user prefix byte is programmed in its hex values.

See example below.

Note: The maximum length for user prefix is 10 bytes.

Program User Prefix

【Pro CMD：0300000】

Program “CODE” as user preﬁx (The hex of “CODE” are 0x43/0x4F/0x44/0x45):

1. Read “Code Programming ON”

2. Read “Program User Preﬁx”

3. Read “4,3,4,F,4,4,4,5” in order

4. Read “Save Programming”

5. Read “Code Programming OFF”.

6. Read “Allow User Preﬁx” to enable above programming. “CODE” will

appear to the left of a barcode.

Disable or Enable User Preﬁx

** Disable User Preﬁx

【Pro CMD：0305000】

Enable User Preﬁx

【Pro CMD：0305010】

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 155 156

Sem comentários

Newland FM420 Manual Página 129