Newland EM1300 Manual descarregar pdf (Página 61)

nlscan.com

Page 52

Data FormatData Format

Tools

Code Programming ON

Code Programming OFF

Terminal

Program a Windows OS general line feed and carrage returen as terminal

1. Read “Code Programming ON”

2. Read “Program Terminal”

3. Read “Set Terminal as 0x0D,0x0A and Enable Sending”

4. Read “Save ”

5. Read “Code Programming OFF”

6. Read “Allow Terminal” to enable above programming. A line feed will ap-

pear to the right of a barcode.

Disable or Enable Terminal

“Terminal” is the termination for a string of barcode messages. It is ﬁxed to the

right and the very end of a barcode transmission.

The major difference between "Terminal" and "User Sufﬁx" is that the information

and the decoded messages in user sufﬁx could be formatted but couldn't in terminal.

Disable Terminal

【Pro CMD：99904110】

Enable Terminal

【Pro CMD：99904111】

Program Terminal

Read “Program Terminal”. Then program terminal byte(s). At last, read “Save programming”. The

terminal byte is programmed in its hex values. See example below.

Program Terminal

【Pro CMD：99904112】

Set Terminal as 0x0D and Enable Sending

【Pro CMD：99904113】

Set Terminal as 0x0D,0x0A and Enable Sending

【Pro CMD：99904114】

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 135 136

Sem comentários

Newland EM1300 Manual Página 61